Keyboardtest.
Check every key, then put a Hall-effect (magnetic) board through two FPS drills: rapid tapping and A/D counter-strafing.
Press any key. Keys light up while held and stay marked once tested. Hold several at once to check rollover.
- Held
- 0
- Max at once
- 0
- Keys tested
- 0
- Chatter
- 0
Rapid tap
Tap one key as fast as you can for 5 seconds. Run it with rapid trigger off, then on, and compare with your last run.
- Taps / sec
- —
- Avg hold
- —
- Avg release gap
- —
- Fastest cycle
- —
Counter-strafe (A/D)
Switch between A and D like you are counter-strafing. We measure the overlap or gap at each switch and spot SOCD / Snap Tap.
- Overlap
- —
- Gap
- —
- Instant
- —
- Everything is measured from the press and release events your keyboard sends. A browser cannot read analog key travel, so it cannot show your actuation point — use your keyboard’s own software for that.
- Rapid trigger re-arms a key as soon as it starts to rise, so releases register earlier: hold time shrinks and tap rate climbs. Run the tap test with it off and on to see the difference on your board.
- In a counter-strafe, overlap means both keys were down (no movement input until you let go); gap means neither was. SOCD resolves the overlap in the keyboard, which shows up here as instant switches.
- Event timing includes your OS and browser, and Fn and some system keys (media keys, Print Screen) may never reach the page. Treat small differences (1–2 ms) as noise.
How do I check that rapid trigger works?
Run the rapid-tap test with rapid trigger off, then turn it on and run it again. With it on, the average hold should drop and taps per second should rise; the "last" line under each number shows your previous run.
What is SOCD / Snap Tap?
When two opposite keys (A and D) are both held, the keyboard only reports the most recent one. In the counter-strafe test that shows up as instant switches: the release and the new press arrive in the same instant. Some games restrict it — CS2 official servers, for example, may kick players who use it — so check the rules where you play.
What does chatter mean?
A key that registers a second press after being released only a few milliseconds earlier — faster than a finger can move. On mechanical switches it is a worn or dirty contact; on Hall-effect boards it often means the rapid-trigger sensitivity is set too fine.
Can this test measure my polling rate or actuation point?
No. Browsers only see press and release events with a timestamp, not analog travel, and keyboard events are not a reliable way to measure polling rate. We only report what the events can actually show.
Why does "max at once" stop at 6?
Your keyboard is probably in 6-key rollover mode (common for BIOS compatibility); many boards have an NKRO toggle. Some key combinations can also be limited by the operating system.